30 Verulam Rd Lambton, NSW 2299 | Phone (02)4952 4544 | Mon-Fri 7am-5pm, Sat 8am-12pm

These polyamides, commonly referred to as Nylons, are distinguished by different types. The most common engineering nylons are PA6 and PA66. Ertalon and Nylatron stock shapes are produced by either Extrusion or Casting. The process is in part a determinant of the character of the end product. Modifiers are added to enhance desirable characteristics. Advantages: Nylon is a tough, durable, general purpose engineering material with special grades for specialty applications. Typical application conditions would be medium speed and temperature in a rugged, abrasive, impact and high load environment.

Results 1 - 14 of 14

Nylon

Ertalon 6PLA

Ertalon 6PLA - The characteristics of this cast nylon grade ...

Ertalon 6 XAU+ Heat Stabilised Nylon

Ertalon 6XAU+ is a heat stabilised cast nylon with a very ...

Nylatron GSM - MoS2 Filled Nylon

Nylatron GSM contains finely divided particles of ...

Ertalon LFX - Oil Filled Nylon

Ertalon LFX oil filled nylon rod and sheet is an internally ...

Ertalon 6SA

Ertalon 6SA - This material offers an optimal combination ...

Ertalon 66SA

Ertalon 66SA - Material with a higher mechanical strength, ...

Nylatron MC901 - Impact Modified Nylon

Nylatron MC901 is a modified cast nylon 6 grade with a ...

Nylatron GS - MoS2 Filled Nylon

Nylatron GS - The addition of MoS2 renders this nylon ...

Ertalon 66GF30 - Glass Filled Nylon

Ertalon 66GF30 - Compared with virgin PA 66 this 30% glass ...

Ertalon 4.6 - High Temperature Nylon

Ertalon 4.6 - Compared with the conventional nylons, ...

Nylatron 703XL - Zero Stick Slip Nylon

Nylatron 703XL is a new internally lubricated cast nylon ...

Nylon Sprockets

Nylon Sprockets - Reduced wear on chain, No lubrication ...

Nylon Gears

Nylon Gears - Reduced wear on mating gear (note: for ...

Nylons - Properties Comparison Table

Nylons - Properties Comparison Table